Please be informed about the modernization of the conveyor belt TOL-1 (hereinafter referred to TOL-2). The design of the TOL-2 have been improved belt tensioning units, added more regulation, allowing to change the displacement of the belt, added the cleaning scraper lower branches, as well as to change the general concept of the assembly (modular design) .Now, thanks to the modular design of the conveyor can RAMS version (conveyor own bed) and built (built into the base frame conveyor log lathe). This decision allows the TOL-2 directly to the base frame log lathe (including previously acquired) and standard tasks of aspiration chips and sawdust in any woodworking shop.  

RAMS execution
Modernised belt conveyor TL-1
Flush-mounting
Modernised belt conveyor TL-1

 Just modularity allows to make several versions of assemblies, thus it is possible to choose one or another variation depending on the wishes of the customer, then presented several options:

                                                                                      Direct (schematic side view)
         It is used to remove the chips into a hopper (Drive), located below the floor.
Modernised belt conveyor TL-1Modernised belt conveyor TL-1

 

 

 Trans + rise (schematic side view)
      It is used to remove the chips into a hopper (Drive) or cart located above the floor.

Modernised belt conveyor TL-1Modernised belt conveyor TL-1

 

Combined (schematic plan view)
It is used for removal of chips perpendicular to the machine frame, structurally it consists of two branches (two conveyors

Modernised belt conveyor TL-1

Read more...